If your truck lays frame, then perhaps you know the heartache of dragging a hole in your gas tank.  Aside from the danger of raw fuel spilling out from under your ride while you're dragging sparks off the frame, gas it too damned expensive to dump on the ground!
Spare yourself from this pain and expense by installing our Gas Tank Crossmember Kit!  This two-piece kit directly replaces the stock gas tank mounts, and only requires minor cutting to install.  This kit will raise your tank above the frame level- approximately 1.5" higher than stock!
These crossmembers come to you with a show-quality bright silver powdercoating- custom colors are available for an extra charge.  Fits Standard and Extended Cab 1/2 Ton Trucks.

NOTE:  Installation requires trimming/ modifying the pinch weld on the back of your truck's cab.  This will not require any interior modifications!
A small section of the bed floor will need to be cut for clearance for your gas tank's sending unit assembly.  A fitted panel is included that may simply be screwed into place, or welded and blended for a factory look.